Owner's Manual

MT-30
[RS5F70A]
TRANSAXLE ASSEMBLY
10. Hammer the new welch plug (striking lever side) with a general-
purpose drift [OD: 12 mm (0.47 in)].
CAUTION:
Do not reuse welch plug.
11. Install selector, selector shaft, and selector shaft pin into clutch
housing.
12. Hammer the new welch plug (selector shaft side) with a general-
purpose drift [OD: 12 mm (0.47 in)].
CAUTION:
Do not reuse welch plug.
13. Install select check leaf spring, return spring, steel ball, reverse
gate, selector arm, bushing, and return bearing.
14. Tighten the two reamer bolts to specification.
CAUTION:
Use correct reamer bolts for each installation point,
because each bolt has a different length.
SMT730D
SMT731D
SMT732D
SMT733DA
SMT734D