Owner's Manual

TRANSAXLE ASSEMBLY
MT-33
[RS5F70A]
D
E
F
G
H
I
J
K
L
M
A
B
MT
3. Calculate dimension “N” (thickness of adjusting shim) using the
following procedure to satisfy specification of end play for differ-
ential side bearing.
Use the “Available Shims” table for the available shim sizes. Refer to MT-65, "
Available Shims — Differen-
tial Side Bearing Preload and Adjusting Shim" .
a. Using dial gauge and scale, measure dimension “N
1 ” between
clutch housing case end face and mounting face of adjusting
shim.
b. Install outer race onto differential side bearing on final gear side.
Holding the outer race horizontally by hand, rotate the final gear
five times or more (for smooth movement of bearing roller).
c. Using dial gauge and scale as shown, measure dimension “N
2 ”
between differential side bearing outer race and transaxle case
end face.
4. Install the selected shim and bearing outer race using Tool.
End play : 0.15 - 0.21 mm (0.0059 - 0.0083 in)
Dimension “N” = (“N
1 ” – “N2 ”) + End play
“N” : Thickness of adjusting shim
“N
1 ” : Distance between clutch housing case
end face and mounting face of adjusting
shim
“N
2 ” : Distance between differential side bearing
and transaxle case
SMT740D
SMT741D
SMT742D
SMT738DA