Owner's Manual

MT-34
[RS5F70A]
TRANSAXLE ASSEMBLY
5. Measure the turning torque of the final drive assembly using
Tool .
● When the old bearing is used again, turning torque will be
slightly less than the above.
● Make sure turning torque is close to the specified range.
● Changes in turning torque of final drive assembly per revolu-
tion should be within 1.0 N-m (10 kg-cm, 8.7 in-lb) without
binding.
6. Calculate dimension “O” (thickness of adjusting shim) using the
following procedure to satisfy specification of end play for input
shaft rear bearing.
Use the “Available Shims” table for the available shim sizes. Refer to MT-62, "
Available Adjusting Shims" .
a. Using block gauge, scale, and dial gauge, measure dimension
“O
1 ” between transaxle case end face and mounting face of
adjusting shim.
b. Using block gauge, scale, and dial gauge as shown in the figure,
measure dimension “O
2 ” between clutch housing case end face
and end face of input shaft rear bearing.
7. Install selected input shaft rear bearing adjusting shim onto input shaft.
Turning torque of
final drive assembly
(New bearing)
: 2.9 - 6.9 N-m (30 - 70 kg-cm,
26 - 61 in-lb)
SMT600-E
End play : 0 - 0.06 mm (0 - 0.0024 in)
Dimension “O” = (“O
1 ” – “O2 ”) + End play
“O” : Thickness of adjusting shim
“O
1 ” : Distance between transaxle case
end face and mounting face of
adjusting shim
“O
2 ” : Distance between clutch housing
case end face and end face of
input shaft rear bearing
SMT743D
SMT744D
SMT745D