Owner's Manual

MT-36
[RS5F70A]
TRANSAXLE ASSEMBLY
13. Install check springs and check balls. Apply sealant to the
thread on the check plug, and install it.
14. Calculate thickness “P” of the adjusting shim using the following
procedure to satisfy the specification of the end play for the
mainshaft rear bearing.
Use the "Available Shims" table for the available shim sizes. Refer to MT-62, "
Available Adjusting Shims" .
a. Using a dial gauge as shown, measure dimension “P
1 ” between
the transaxle case end face and the mainshaft rear bearing.
b. Using a dial gauge as shown, measure dimension “P
2 ” between
the adjusting shim mounting face of rear cover and the transaxle
mounting face.
SMT749D
End play : 0 - 0.06 mm (0 - 0.0024 in)
Dimension “P” = (“P
1 ” – “P2 ”) + End play
“P” : Thickness of adjusting shim
“P
1 ” : Distance between transaxle case
end face and mainshaft rear bearing
“P
2 ” : Distance between adjusting shim
end face of rear cover and transaxle
mounting face
SMT746D
SMT747D
SMT748D