Owner's Manual

TRANSAXLE ASSEMBLY
MT-37
[RS5F70A]
D
E
F
G
H
I
J
K
L
M
A
B
MT
15. Using snap ring pliers and flat-head screwdriver as shown,
install snap ring.
CAUTION:
Do not reuse snap ring.
16. Install selected mainshaft adjusting shim.
17. Install reverse idler gear, O-ring, thrust washers (front and rear),
and bearing onto reverse idler shaft.
18. Install snap ring into transaxle case using snap ring pliers.
CAUTION:
● Do not reuse snap ring.
● Do not reuse O-ring.
● Before installation, apply gear oil to O-ring.
19. Using feeler gauge, measure the end play of snap ring, and
select a snap ring suitable to meet the specified end play.
Use the "Available Shims" table for the available shim sizes.
Refer to MT-61, "
Available Snap Rings" .
20. Install selected snap ring with a suitable tool.
CAUTION:
Do not reuse snap ring.
21. Apply gear oil to rear cover O-ring, and install rear cover, side
cover gasket, and side cover. Then tighten mounting bolts with
specified torque.
Use the "Available Shims" table for the available shim sizes.
Refer to MT-18, "
CASE COMPONENTS" .
CAUTION:
Do not reuse mounting bolts for rear cover and side cover.
SMT646D
SMT753DA
End play : 0.05 - 0.25 mm (0.0020 - 0.0098 in)
SMT754D
SMT644D