Owner's Manual

INPUT SHAFT AND GEARS
MT-43
[RS5F70A]
D
E
F
G
H
I
J
K
L
M
A
B
MT
10. Position 5th input gear as shown, to install it on input shaft.
11. Install 5th input gear using Tool as shown.
CAUTION:
Do not reuse 5th input gear.
12. Install 5th gear rear C-ring onto input shaft using Tool.
13. Measure the end play of 5th input gear with a suitable tool, and
check if it is within the allowable specification below.
14. If not within specification, adjust the end play by changing thickness of the 5th (input gear) rear C-ring.
Refer to MT-61, "
Available C-rings" .
15. Install C-ring holder onto 5th gear rear C-ring using Tool.
CAUTION:
Do not reuse C-ring holder.
16. Install input shaft rear bearing using Tool.
CAUTION:
Install input shaft rear bearing with its brown surface facing
the input gear side.
SMT703D
SMT702DA
End play : 0 - 0.06 mm (0 - 0.0024 in)
SMT704D
SMT705DA