Owner's Manual

MT-56
[RS5F70A]
FINAL DRIVE
7. Remove pinion mate shaft.
8. Rotate pinion mate gear, and remove pinion mate gear, pinion
mate thrust washer, side gear, and side gear thrust washer from
differential case.
Inspection ECS005TY
GEAR, WASHER, SHAFT AND CASE
● Check mating surfaces of differential case, side gears and pin-
ion mate gears.
● Check washers for wear.
BEARING
● Make sure bearings roll freely and are free from noise, cracks,
pitting or wear.
CAUTION:
When replacing tapered roller bearing, replace outer and
inner race as a set.
Assembly ECS005TZ
1. Apply gear oil to sliding area of differential case, each gear, and
thrust washer.
2. Install side gear thrust washer and side gear into differential
case.
3. Position pinion mate gear and pinion mate thrust washer diago-
nally, and install them into differential case while rotating.
SMT839
WCIA0004E
SPD715
SMT062A