Owner's Manual

FINAL DRIVE
MT-57
[RS5F70A]
D
E
F
G
H
I
J
K
L
M
A
B
MT
4. Insert pinion mate shaft into differential case.
5. Upright the differential case so that its side gear to be measured
faces upward.
6. Place preload adapter and dial gauge onto side gear. Move side
gear up and down, and measure the clearance using Tool.
7. Turn differential case upside down, and measure the clearance
between side gear and differential case on the other side in the
same way using Tool.
8. Install retaining pin using Tool.
● Make sure that retaining pin is flush with case.
9. Align and install speedometer drive gear into differential case.
10. Install speedometer stopper.
SMT087A
Clearance of side
gear and differential
case
: 0.1 - 0.2 mm (0.004 - 0.008 in)
Differential side gear
thrust washers
: Refer to MT-64, "
Available
Washers" .
SMT685DA
SMT699B
SMT842D