Owner's Manual

CONTROL LINKAGE

MT-77

[RS6F51H]

CAUTION:

● Note that the select side lock plate for securing the control cable is different from the one on the

shift side.

● After assembly, make sure selector lever automatically returns to Neutral when it is moved to 1st,

2nd, or Reverse.

Cable Adjustment

ECS006S7

NOTE:

After installation of the select cable, the cable must be adjusted for proper operation. This adjustment is per-

formed before installing the interior console and shift boot.

1. Slide clip “B” from under clip “A” as shown.

2. Shift the control lever to the neutral position.

CAUTION:

Do not move the control lever when adjusting the cables.

3. Push clip “A” into the cable end case until it snaps into place as

shown.

4. Slide clip “B” back over clip “A” until it snaps into place and holds

clip “A” in place as shown.

13. Control device assembly 14. Cover 15. Select cable

16. Floor 17. Pin 18. Shift cable

19. Washer 20. Clutch housing 21. Cable mounting bracket

22. Select cable 23. Shift cable 24. Lock plate

25. Lock plate

LCIA0303E

LCIA0304E

LCIA0305E