Owner's Manual

TRANSAXLE ASSEMBLY
MT-79
[RS6F51H]
D
E
F
G
H
I
J
K
L
M
A
B
MT
TRANSAXLE ASSEMBLY PFP:32010
Removal and Installation ECS005VD
REMOVAL
1. Remove the air cleaner and air duct.
2. Remove the battery.
3. Remove the air breather hose.
4. Remove the clutch operating cylinder.
CAUTION:
Do not depress the clutch pedal during the removal procedure.
5. Remove the engine under cover.
6. Disconnect the control cable from the transaxle. Refer to MT-76, "
Removal and Installation of Control
Device and Cable" .
7. Drain the gear oil from the transaxle. Refer to MA-30, "
Changing M/T Oil" .
8. Remove the connectors and harnesses for:
● PNP switch
● Speed sensor
● Back-up lamp switch
● Ground
9. Remove the exhaust front tube. Refer to EX-3, "
Removal and Installation" .
10. Remove the drive shaft. Refer to FAX-14, "
Removal" .
11. Remove the starter motor. Refer to SC-20, "
Removal and Installation" .
12. Place a suitable jack under the transaxle.
CAUTION:
When setting the jack, be careful not to bring it into contact with the switches.
13. Remove the center member, engine insulator, and engine mount bracket.
14. Support the engine by placing a jack under the engine oil pan.
WCIA0109E