Owner's Manual

MT-86
[RS6F51H]
TRANSAXLE ASSEMBLY
5. Remove the transaxle case bolts as shown.
6. Remove the bore plug.
CAUTION:
Be careful not to damage transaxle case.
7. While spreading the snap ring of the mainshaft rear bearing located at bore plug hole, remove the tran-
saxle case.
8. Remove the oil gutter and baffle plate.
9. Remove the snap ring, mainshaft rear bearing adjusting shim, and input shaft rear bearing adjusting shim
from the transaxle case.
10. Remove the differential side bearing outer race (transaxle case
side) using Tool as shown, and then remove the adjusting shim.
11. Remove the welch plug with a suitable punch and hammer as
shown.
12. Remove the differential oil seal with a suitable tool as shown.
13. Remove the magnet from the clutch housing.
SCIA0983E
SCIA1021E
SCIA0402E
SCIA0397E