Owner's Manual

MT-88
[RS6F51H]
TRANSAXLE ASSEMBLY
24. Remove the retaining pin of 3rd-4th bracket using pin punch.
25. Remove the stopper rings for 3rd-4th shift fork.
26. Pull out the 3rd-4th fork rod and remove 3rd-4th shift fork and bracket.
27. Remove the shift check sleeve from the clutch housing.
28. Remove the retaining pin of 1st-2nd shift fork using a suitable
pin punch.
29. Pull out the 1st-2nd fork rod with bracket.
30. Remove the 1st-2nd shift fork.
31. Remove the retaining pin of 1st-2nd bracket using a suitable pin punch and separate the fork rod and
bracket.
32. Remove the gear components from the clutch housing.
a. While tapping the input shaft with a plastic hammer, remove the
input shaft assembly, mainshaft assembly, and reverse idler
gear assembly as a set.
CAUTION:
Always withdraw the mainshaft straight out. Failure to do
so can damage the resin oil channel on the clutch housing
side.
b. Remove the final drive assembly.
33. Remove the bearing retainer and then the mainshaft front bear-
ing as shown.
34. Remove the oil channel on the mainshaft side.
SCIA0393E
SCIA0394E
SCIA0964E
SCIA0400E