Owner's Manual

MTC-80
IN-CABIN MICROFILTER
Revision: March 2005 2005 Altima
IN-CABIN MICROFILTER PFP:27277
Removal and Installation EJS002SX
FUNCTION
Air inside passenger compartment is kept clean at either recircula-
tion or fresh mode by installing in-cabin microfilter into blower unit.
REPLACEMENT TIMING
Replace in-cabin microfilter.
Refer to MA-7, "
SCHEDULE 1" and MA-10, "SCHEDULE 2" .
Caution label is fixed inside the glove box.
REPLACEMENT PROCEDURES
1. Remove the glove box pins. Refer to IP-14, "Instrument Lower Cover RH and Glove Box" .
2. Press in the sides of the glove box door to release the glove box door from the glove box housing.
3. Disconnect the glove box damper cord to remove the glove box door.
4. Disengage the two filter cover tabs to remove the filter cover.
5. Remove the in-cabin microfilter from the blower unit.
6. Install the new in-cabin microfilter into the blower unit.
CAUTION:
● Insert the new filter with the “UP” arrow in the correct ori-
entation.
● Insert the new filter with the “UP” arrow side of the filter
facing the rear of the vehicle.
7. Install the filter cover on the blower unit.
8. Connect the glove box damper cord to the glove box door.
9. Press in the sides of the glove box door to install the glove box
door into the glove box housing.
10. Install the glove box pins.
LJIA0012E
LJIA0013E