Owner's Manual

REFRIGERANT LINES
MTC-95
C
D
E
F
G
H
I
K
L
M
A
B
MTC
Revision: March 2005 2005 Altima
2. Remove the center bolt by holding the clutch disc steady using
Tool.
3. Remove the clutch disc.
4. Remove the snap ring using external snap ring pliers.
5. Remove the pulley assembly using Tool.
● Use a pulley puller with a small adapter. Position the small
adapter on the end of the compressor shaft and the center of
the puller on the small adapter as shown.
CAUTION:
To prevent deformation of the pulley groove, the puller
claws should be hooked under (not into) the pulley groove.
6. Remove the snap ring using external snap ring pliers.
7. Remove the magnet coil harness clip using a screwdriver.
Tool number : (J-44614)
WHA228
RHA072C
Tool number : KV99233130 (J-29884)
WJIA1017E
WHA212