Owner's Manual

REFRIGERANT LINES
MTC-97
C
D
E
F
G
H
I
K
L
M
A
B
MTC
Revision: March 2005 2005 Altima
5. Install the center bolt using Tool.
● After tightening the center bolt to specification, check that the
pulley rotates smoothly.
INSPECTION AFTER INSTALLATION
Check the clearance all the way around the clutch disc as shown.
If the specified clearance is not obtained, replace the adjusting
spacer and recheck the clearance.
BREAK-IN OPERATION
When replacing compressor clutch assembly, always conduct the break-in operation. This is done by engag-
ing and disengaging the clutch about 30 times. Break-in operation raises the level of transmitted torque.
Center bolt : 12 N·m (1.2 kg-m, 9 ft-lb).
Tool number : (J-44614)
WHA229
Clutch disc-to-pulley clearance : 0.3 - 0.6 mm
(0.012 - 0.024 in)
WHA194