Owner's Manual

MT-100
[RS6F51A]
TRANSAXLE ASSEMBLY
Revision: March 2005 2005 Altima
2. Using a depth micrometer and straight edge, measure the
dimension “O
2 ” between the clutch housing case end face and
end face of the input shaft rear bearing as shown.
3. Install the selected input shaft rear bearing adjusting shim onto the input shaft.
DIFFERENTIAL SIDE BEARING PRELOAD
● When adjusting differential side bearing preload, select adjust-
ing shim for differential side bearing. To select adjusting shim,
measure clearance “L” between transaxle case and differential
side bearing outer race.
● Calculate dimension “L” (thickness of adjusting shim) using the
following procedure to meet specification of preload for differen-
tial side bearing.
CAUTION:
Up to only 2 adjusting shims can be selected.
Adjusting Shim
1. Using a depth micrometer and straight edge, measure the
dimension “L
1 ” between the transaxle case end face and
mounting face of the adjusting shim as shown.
SCIA1004E
Preload : 0.15 - 0.21 mm (0.0059 - 0.0083 in)
Dimension “L” = (“L
1 ” - “L2 ”) + Preload
“L” : Thickness of adjusting shim
“L
1” : Distance between transaxle case end face
and mounting face of adjusting shim
“L
2” : Distance between differential side bearing
and clutch housing end face
SCIA0896E
Shim thickness Part number
0.48 mm (0.0189 in)
0.52 mm (0.0205 in)
0.56 mm (0.0220 in)
0.60 mm (0.0236 in)
0.64 mm (0.0252 in)
0.68 mm (0.0268 in)
0.72 mm (0.0283 in)
0.76 mm (0.0299 in)
0.80 mm (0.0315 in)
0.84 mm (0.0331 in)
0.88 mm (0.0346 in)
0.92 mm (0.0362 in)
31438 80X00
31438 80X01
31438 80X02
31438 80X03
31438 80X04
31438 80X05
31438 80X06
31438 80X07
31438 80X08
31438 80X09
31438 80X10
31438 80X11
SCIA1078E