Owner's Manual

MT-104
[RS6F51A]
INPUT SHAFT AND GEARS
Revision: March 2005 2005 Altima
INPUT SHAFT AND GEARS PFP:32200
Disassembly and Assembly ECS00BT6
DISASSEMBLY
1. Before disassembling, measure the end play for the 3rd, 4th,
5th, and 6th input gears.
CAUTION:
If the measurement is outside the standard value, disas-
semble to check the contact surfaces of the gear, shaft, and
hub. Adjust using the correct size snap ring for assembly.
2. Remove the oil channel.
3. Remove the input shaft rear bearing using Tool as shown.
4. Remove the snap ring.
5. Remove the 6th input gear, 6th bushing, and 6th needle bearing
using Tool as shown.
6. Remove the 6th baulk ring, 5th-6th coupling sleeve, and shifting
insert.
7. Remove the 5th input gear and synchronizer hub assembly
simultaneously using Tool as shown.
8. Remove the 5th needle bearing.
End play standard values
3rd gear : 0.18 - 0.31 mm (0.0071 - 0.0122 in)
4th gear : 0.20 - 0.30 mm (0.0079 - 0.0118 in)
5th gear : 0.06 - 0.16 mm (0.0024 - 0.0063 in)
6th gear : 0.06 - 0.16 mm (0.0024 - 0.0063 in)
SCIA0966E
Tool number A: Commercial service tool
B: ST33052000 ( — )
WCIA0306E
Tool number A: Commercial service tool
B: ST33052000 ( — )
WCIA0307E
Tool number A: KV40105020 ( — )
B: Commercial service tool
WCIA0281E