Owner's Manual

INPUT SHAFT AND GEARS
MT-105
[RS6F51A]
D
E
F
G
H
I
J
K
L
M
A
B
MT
Revision: March 2005 2005 Altima
9. Remove the 5th bushing, thrust washer, 4th input gear, 4th nee-
dle bearing, 4th bushing, 4th baulk ring, 3rd-4th synchronizer
hub assembly, 3rd baulk ring, and 3rd input gear simultaneously
using Tool as shown.
10. Remove the 3rd needle bearing.
11. Remove the input shaft front bearing using Tool as shown.
INSPECTION AFTER DISASSEMBLY
Input Shaft and Gear
Check the items listed. If necessary, replace them with new ones.
● Damage, peeling, dent, uneven wear, or bending of the input
shaft.
● Excessive wear, damage, or peeling of the input gears.
Synchronizer
Check the items listed. If necessary, replace them with new ones.
● Damage and excessive wear of the contact surfaces of coupling
sleeve, synchronizer hub, and shifting insert.
● Coupling sleeve and synchronizer hub must move smoothly as
shown.
Tool number A: ST33052000 ( — )
B: Commercial service tool
WCIA0282E
SCIA0920E
SMT636A
SMT387A