Owner's Manual

MT-106
[RS6F51A]
INPUT SHAFT AND GEARS
Revision: March 2005 2005 Altima
● If any cracks, damage, or excessive wear is found on the cam
face of baulk ring or working face of the insert as shown, replace
it.
Baulk Ring Clearance for Single Cone Synchronizer (4th, 5th and 6th)
● Press the baulk ring against cone, and measure clearance
between baulk ring and cone. If measurement is below limit,
replace it with a new one.
Baulk Ring Clearance for Double-cone Synchronizer (3rd)
●
Follow the instructions below and inspect the clearance of the
outer baulk ring, synchronizer cone, and inner baulk ring.
CAUTION:
Outer baulk ring, synchronizer cone, and inner baulk ring
act as a set to control the clearances “A” and “B”. If the
measurement exceeds the service limit value, replace all of
them as a set.
1. Using a dial gauge and Tool, measure clearance “A” at two or
more points diagonally opposite, and calculate mean value.
SMT867D
Clearance - standard
4th : 0.9 - 1.45 mm (0.035 - 0.0571 in)
5th and 6th : 0.95 - 1.4 mm (0.0374 - 0.055 in)
Limit : 0.7 mm (0.028 in)
SMT140
SMT138E
Tool number : ST30031000 (J-22912-01)
Clearance “A”
Standard : 0.6 - 0.8 mm (0.024 - 0.031 in)
Limit value : 0.2 mm (0.008 in)
WCIA0283E