Owner's Manual

MT-110
[RS6F51A]
INPUT SHAFT AND GEARS
Revision: March 2005 2005 Altima
14. Install the needle bearing, 6th input gear and then 6th bushing
using Tool as shown.
15. Install the snap ring onto the input shaft, and measure to check
that end play (gap between snap ring and groove) of the 6th
bushing is within specification.
● If the measurement is outside the standard value, select the
appropriate size snap ring.
Snap Rings
16. Install the input shaft rear bearing using Tool as shown.
CAUTION:
Install input shaft rear bearing with its brown surface facing
the input gear side.
17. Install the input shaft front bearing using Tool as shown.
18. Install the oil channel onto the input shaft.
Tool number : ST33200000 (J-26082)
WCIA0309E
End play standard value : 0 - 0.1 mm (0 - 0.004 in)
SCIA0970E
Thickness Part number Thickness Part number
1.76 mm (0.0693 in)
1.81 mm (0.0713 in)
1.86 mm (0.0732 in)
1.91 mm (0.0752 in)
1.96 mm (0.0772 in)
32204 8H511
32204 8H512
32204 8H513
32204 8H514
32204 8H515
2.01 mm (0.0791 in)
2.06 mm (0.0811 in)
2.11 mm (0.0831 in)
2.16 mm (0.0850 in)
2.21 mm (0.0871 in)
32204 8H516
32204 8H517
32204 8H518
32204 8H519
32204 8H520
Tool number : ST30901000 (J-26010-01)
WCIA0310E
Tool number A: ST33052000 ( — )
B: ST30032000 (J-26010-01)
WCIA0311E