Owner's Manual

MT-112
[RS6F51A]
MAINSHAFT AND GEARS
Revision: March 2005 2005 Altima
MAINSHAFT AND GEARS PFP:32241
Disassembly and Assembly ECS00BT7
DISASSEMBLY
1. Before disassembling, measure the end play of the 1st and 2nd
main gears as shown.
CAUTION:
If the measurement is outside the standard value, disas-
semble to check the contact surfaces of the gear, shaft, and
hub. Adjust with the snap ring at assembly.
2. Remove the snap ring.
3. Remove the C-ring holder, and then mainshaft C-ring as shown.
4. Remove the mainshaft rear bearing, adjust shim, and 6th main
gear using Tool as shown.
5. Remove the 5th-6th mainshaft spacer.
6. Remove the 4th main gear and 5th main gear simultaneously
using Tool as shown.
7. Remove the adjusting shim.
8. Remove the 3rd-4th mainshaft spacer.
End play standard values
1st gear : 0.20 - 0.30 mm (0.0079 - 0.0118 in)
2nd gear : 0.06 - 0.16 mm (0.0024 - 0.0063 in)
SCIA0973E
SCIA0974E
Tool number A: Commercial service tool
B: ST33052000 ( — )
WCIA0312E
Tool number A: ST33052000 ( — )
B: Commercial service tool
WCIA0292E