Owner's Manual

MT-114
[RS6F51A]
MAINSHAFT AND GEARS
Revision: March 2005 2005 Altima
Triple Cone Synchronizer (1st and 2nd)
● Check the clearance of the outer baulk ring, synchronizer cone,
and inner baulk ring of the 1st and 2nd triple cone synchroniz-
ers, using the following procedure.
CAUTION:
The outer baulk ring, synchronizer cone, and inner baulk
ring operate as a set to control the clearances “A”, “B”, and
“C”. If the measured clearances exceed the service limit
value, replace the components as a set.
NOTE:
To calculate the mean value of two or more measured values,
add the highest and lowest measured values and divide by two.
1. Press the baulk ring on to the clutch gear taper cone by hand,
then measure the clearance “A” at two or more points diagonally
opposite with a feeler gauge, and then calculate the mean value.
2. Measure clearances “B” at two or more points diagonally oppo-
site with a feeler gauge, and then calculate the mean value.
3. Press the baulk ring on to the clutch gear taper cone by hand,
then measure the clearance “C” at two or more points diagonally
opposite with a feeler gauge, and then calculate the mean value.
WCIA0195E
Clearance “A”
Standard : 0.6 - 1.2 mm (0.024 - 0.047 in)
Limit : 0.3 mm (0.012 in)
LCIA0298E
Clearance “B”
Standard : 0.6 - 1.1 mm (0.024 - 0.043 in)
Limit : 0.2 mm (0.008 in)
SCIA1084E
Clearance “C”
Standard : 0.7 - 1.1 mm (0.028 - 0.043 in)
Limit : 0.3 mm (0.012 in)
LCIA0300E