Owner's Manual

MAINSHAFT AND GEARS
MT-119
[RS6F51A]
D
E
F
G
H
I
J
K
L
M
A
B
MT
Revision: March 2005 2005 Altima
Adjusting Shim
a. Using a height gauge, measure the dimension “S
1 ” and “S2 ” as shown.
b. Install the selected 6th main adjusting shim to the mainshaft.
17. Install the mainshaft rear bearing using Tool as shown.
18. Install the C-ring onto the mainshaft, and check that the end play
of mainshaft rear bearing meets specifications.
● If the measurement is outside the specified standard value,
reselect a new C-ring.
C-Ring
19. Fit the C-ring holder, and install the snap ring as shown.
Thickness Part number Thickness Part number
0.88 mm (0.0346 in)
0.96 mm (0.0378 in)
1.04 mm (0.0409 in)
1.12 mm (0.0441 in)
32237 8H560
32237 8H561
32237 8H562
32237 8H563
1.20 mm (0.0472 in)
1.28 mm (0.0504 in)
1.36 mm (0.0535 in)
32237 8H564
32237 8H565
32237 8H566
Tool number A: ST30720000 (J-25405)
B: ST30901000 (J-26010-01)
WCIA0314E
End play standard value : 0 - 0.06 mm (0 - 0.0024 in)
SCIA0979E
Thickness Part number Thickness Part number
2.535 mm (0.0998 in)
2.565 mm (0.1010 in)
2.595 mm (0.1022 in)
2.625 mm (0.1033 in)
2.655 mm (0.1045 in)
2.685 mm (0.1057 in)
2.715 mm (0.1069 in)
2.745 mm (0.1081 in)
2.775 mm (0.1093 in)
2.805 mm (0.1104 in)
32348 8H800
32348 8H801
32348 8H802
32348 8H803
32348 8H804
32348 8H805
32348 8H806
32348 8H807
32348 8H808
32348 8H809
2.835 mm (0.1116 in)
2.865 mm (0.1128 in)
2.895 mm (0.1140 in)
2.925 mm (0.1152 in)
2.955 mm (0.1163 in)
2.985 mm (0.1175 in)
3.015 mm (0.1187 in)
3.045 mm (0.1199 in)
3.075 mm (0.1211 in)
32348 8H810
32348 8H811
32348 8H812
32348 8H813
32348 8H814
32348 8H815
32348 8H816
32348 8H817
32348 8H818
SCIA0974E