Owner's Manual

FINAL DRIVE
MT-125
[RS6F51A]
D
E
F
G
H
I
J
K
L
M
A
B
MT
Revision: March 2005 2005 Altima
2. Install side gear thrust washers and side gears into differential
case as shown.
3. While rotating pinion mate thrust washers and pinion mate gears, and aligning them diagonally, install
them into differential case.
4. Insert pinion mate shaft into differential case as shown.
CAUTION:
Be sure not to damage pinion mate thrust washers.
5. Measure end play of side gears, using the procedure below.
Then select side gear thrust washer.
a. Upright the differential case so that the side gear to be mea-
sured faces upward.
b. Place final drive adapter and dial indicator onto side gears using
tool as shown.
c. Move side gears up and down to measure end play, and select
thrust washer so that it meets specification.
CAUTION:
● There must be no resistance and the gears must rotate
freely.
● Place differential case upside down. Measure the end
play for opposite side-gears using the same procedure.
● Only one thrust washer can be selected.
Thrust washers
SMT839
MTK0132D
Tool number : — (J-39713)
WCIA0261E
End play standard value : 0.1 - 0.2 mm (0.004 - 0.008 in)
SMT611A
Thickness Part number
0.75 mm (0.0295 in)
0.80 mm (0.0315 in)
0.85 mm (0.0335 in)
0.90 mm (0.0354 in)
0.95 mm (0.0374 in)
38424 81X00
38424 81X01
38424 81X02
38424 81X03
38424 81X04