Owner's Manual

TRANSAXLE ASSEMBLY
MT-31
[RS5F51A]
D
E
F
G
H
I
J
K
L
M
A
B
MT
Revision: March 2005 2005 Altima
CAUTION:
Stopper rings are not reusable. Never reuse them.
18. Install retaining pin onto 5th shift fork.
CAUTION:
Retaining pins are not reusable. Never reuse them.
19. Install reverse shift fork and reverse fork rod.
20. Install reverse lever assembly following procedures below.
a. Install shifter cap onto reverse lever assembly cam, and then install them onto reverse shift fork.
CAUTION:
Do not drop shifter cap.
b. While lifting reverse shift fork, align cam with 5th-reverse
bracket.
c. Tighten mounting bolts to specified torque, and then install
reverse lever assembly.
21. Install the magnet onto clutch housing.
22. Install the selected input shaft adjusting shim onto the input shaft.
● For selection of adjusting shims, refer to MT-66, "Available Adjusting Shims" .
23. Install selected differential side bearing adjusting shim and differential side bearing outer race. For selec-
tion adjusting shim, refer to MT-35, "
DIFFERENTIAL SIDE BEARING PRELOAD" .
24. Install baffle plate and oil gutter.
25. Install transaxle case using the following procedure:
a. Install selected mainshaft rear bearing adjusting shim into transaxle case.
● For selection of adjusting shims, refer to MT-66, "Available Adjusting Shims" .
b. Temporarily install a new snap ring of mainshaft rear bearing into transaxle case.
CAUTION:
Do not reuse the snap ring.
SCIA0391E
SCIA0890E
Bracket bolts : 11.8 – 15.6 N·m (1.2 – 1.5 kg-m,
9 – 11 ft-lb)
SCIA0390E