Owner's Manual

INPUT SHAFT AND GEARS
MT-39
[RS5F51A]
D
E
F
G
H
I
J
K
L
M
A
B
MT
Revision: March 2005 2005 Altima
INPUT SHAFT AND GEARS PFP:32200
Disassembly and Assembly ECS0094E
DISASSEMBLY
1. Before disassembling, measure end play for 3rd, 4th, and 5th
input gears.
CAUTION:
If measurement is outside the standard range, disassemble
to check contact surfaces of gear, shaft, and hub. Adjust
with snap ring at assembly.
2. Remove oil channel.
3. Remove input shaft rear bearing.
4. Remove the snap ring.
5. Remove input shaft bearing spacer and 5th stopper simulta-
neously.
End play standard value
3rd gear : 0.18 - 0.31 mm (0.0071 - 0.0122 in)
4th gear : 0.20 - 0.30 mm (0.0079 - 0.0118 in)
5th gear : 0.06 - 0.16 mm (0.0024 - 0.0063 in)
SCIA0914E
Tool number A: ST33052000 ( — )
B: Commercial service tool
WCIA0279E
SCIA0916E
Tool number A: ST33052000 ( — )
B: Commercial service tool
WCIA0280E