Owner's Manual

MAINSHAFT AND GEARS
MT-49
[RS5F51A]
D
E
F
G
H
I
J
K
L
M
A
B
MT
Revision: March 2005 2005 Altima
● If any crack, damage, or excessive wear is found on cam face of
baulk ring or working face of insert, replace it.
Baulk Ring Clearance for Double Cone Synchronizer (1st)
Follow the instructions below and inspect the clearance of outer
baulk ring, synchronizer cone, and inner baulk ring.
CAUTION:
Outer baulk ring, synchronizer cone and inner baulk ring deter-
mine the clearances “A” and “B” as an assembly. Replace the
outer baulk ring, synchronizer cone and inner baulk ring as an
assembly if either of the clearances “A” or “B” exceed the limit
value.
● Using a dial gauge, measure clearance “A” at 2 or more points
diagonally opposite, and calculate mean value.
● Using a feeler gauge, measure clearance “B” at 2 or more points
diagonally opposite, and calculate mean value.
SMT867D
SCIA0950E
Tool number : ST30031000 (J-22912-01)
Clearance “A”
Standard value : 0.6 - 0.8 mm (0.024 - 0.031 in)
Limit value : 0.2 mm (0.008 in)
WCIA0283E
Clearance “B”
Standard value : 0.6 - 1.1 mm (0.024 - 0.043 in)
Limit value : 0.2 mm (0.008 in)
SCIA1084E