Owner's Manual

MT-50
[RS5F51A]
MAINSHAFT AND GEARS
Revision: March 2005 2005 Altima
Baulk Ring Clearance for Triple Cone Synchronizer (2nd)
Follow the instructions below and inspect the clearance of outer
baulk ring, synchronizer cone, inner baulk ring.
CAUTION:
Outer baulk ring, synchronizer cone and inner baulk ring deter-
mine the clearances “A”, “B” and ”C” as an assembly. Replace
the outer baulk ring, synchronizer cone and inner baulk ring as
an assembly if any of the clearances “A”, “B” and “C” exceed
the limit value.
● Measure clearance “A” at two points or more on the opposite
side using a feeler gauge when pressing baulk ring toward
clutch gear taper cone, then calculate the average.
● Measure clearance “B” at two points or more on the opposite
side using a feeler gauge, then calculate the average.
● Measure clearance “C” at two points or more on the opposite
side using a feeler gauge when pressing baulk ring toward
clutch gear taper cone, then calculate the average.
PCIB0603E
Clearance “A”
Standard value : 0.6 - 1.2 mm (0.024 - 0.047 in)
Limit value : 0.3 mm (0.012 in)
PCIB0808E
Clearance “B”
Standard value : 0.6 - 1.1 mm (0.024 - 0.043 in)
Limit value : 0.2 mm (0.008 in)
PCIB0605E
Clearance “C”
Standard value : 0.7 - 1.1 mm (0.028 - 0.043 in)
Limit value : 0.3 mm (0.012 in)
PCIB0809E