Owner's Manual

MT-60
[RS5F51A]
FINAL DRIVE
Revision: March 2005 2005 Altima
2. Install side gear thrust washers and side gears into differential
case.
3. While rotating pinion mate thrust washers and pinion mate gears, aligning them diagonally, install them
into differential case.
4. Insert pinion mate shaft into differential case.
CAUTION:
Be sure not to damage pinion mate thrust washers.
5. Measure end play of side gears using the procedure below, then
select a side gear thrust washer.
a. Upright the differential case so that its side gear to be measured
face upward.
b. Place final drive adapter and dial indicator onto side gears.
c. Move side gears up and down to measure end play, and select
thrust washer so that it satisfies standard.
CAUTION:
● There should be no resistance with the gears rotating
freely.
● Place differential case upside down. Be sure to measure
end play for opposite side-gears likewise.
Thrust washer
CAUTION:
Only one thrust washer can be selected.
SMT839
MTK0132D
Tool number : — (J-39713)
WCIA0261E
End play standard : 0.1 - 0.2 mm (0.004 - 0.008 in)
SMT611A
Thickness Part number
0.75 mm (0.0295 in)
0.80 mm (0.0315 in)
0.85 mm (0.0335 in)
0.90 mm (0.0354 in)
0.95 mm (0.0374 in)
38424 81X00
38424 81X01
38424 81X02
38424 81X03
38424 81X04