Owner's Manual
M/T OIL
MT-75
[RS6F51A]
D
E
F
G
H
I
J
K
L
M
A
B
MT
Revision: March 2005 2005 Altima
M/T OIL PFP:KLD20
Replacement ECS0094W
DRAINING
1. Start the engine and let it run to warm up the transaxle oil.
2. Stop the engine. Remove drain plug and drain oil.
3. Set a gasket on the drain plug and install it in the transaxle case.
CAUTION:
Do not reuse gasket.
FILLING
1. Remove speedometer pinion gear. Fill transaxle with new oil.
2. After refilling oil, check oil level. Set a new O-ring on the speedometer pinion gear, then install it in tran-
saxle case.
CAUTION:
Do not reuse O-ring.
Checking ECS0094X
OIL LEAKAGE AND OIL LEVEL
● Check that oil is not leaking from transaxle.
● Remove speedometer pinion gear.
● Measure oil level using suitable gauge as shown, and check if
"L" is within the specifications.
CAUTION:
Never start engine while checking oil level.
● Set a new O-ring on the speedometer pinion gear, then install it in the transaxle case.
CAUTION:
Do not reuse O-ring.
Drain plug : 34.5 N·m (3.5 kg-m, 25 ft-lb)
Oil grade and capacity : Refer to MA-12, "
Fluids and Lubricants" .
Speedometer pinion gear : 5.6 N·m (0.6 kg-m, 50 in-lb)
Oil level “L” : 49 - 55 mm (1.93 - 2.17 in)
SMT512C
Speedometer pinion
gear
: 5.6 N·m (0.6 kg-m, 50 in-lb)