Owner's Manual

MT-96
[RS6F51A]
TRANSAXLE ASSEMBLY
Revision: March 2005 2005 Altima
24. Install the reverse lever assembly using the following steps:
a. Install the shifter cap onto the reverse lever assembly cam, and then install them onto the reverse shift
fork.
CAUTION:
Do not drop the shifter cap.
b. While lifting the reverse shift fork, align the cam with the reverse
bracket.
c. Tighten the bracket bolts to specification, and install the reverse
lever assembly.
25. Install the check ball, reverse shift check sleeve, reverse check spring, and the reverse check ball plug.
CAUTION:
● Do not reuse the check ball plug.
● Do not drop the check ball.
26. Install the magnet onto the clutch housing.
27. Install the selected input shaft adjusting shim onto the input shaft. Refer to MT-99, "
INPUT SHAFT END
PLAY" .
28. Install selected differential side bearing adjusting shim and differential side bearing outer race. Refer to
MT-100, "
DIFFERENTIAL SIDE BEARING PRELOAD" .
29. Install the baffle plate and oil gutter.
30. Install the transaxle case using the following steps:
a. Install the selected mainshaft rear bearing adjusting shim into the transaxle case. Refer to MT-101,
"MAINSHAFT END PLAY" .
b. Temporarily install the snap ring of the mainshaft rear bearing into the transaxle case.
CAUTION:
Do not reuse the snap ring.
c. Apply sealant to the mating surfaces of the transaxle case and
clutch housing as shown. Use Genuine Silicone RTV or equiva-
lent. Refer to GI-45, "
RECOMMENDED CHEMICAL PROD-
UCTS AND SEALANTS" .
CAUTION:
Remove any old sealant adhering to the mounting surfaces.
Also remove any moisture, oil, or foreign material adhering
to the sealant application and mounting surfaces.
SCIA0965E
Bracket bolts : 13.7 N·m (1.4 kg-m, 10 ft-lb)
SCIA0960E
SCIA0891E