Owner's Manual

TRANSAXLE ASSEMBLY
MT-97
[RS6F51A]
D
E
F
G
H
I
J
K
L
M
A
B
MT
Revision: March 2005 2005 Altima
d. Using a snap ring of the mainshaft rear bearing temporarily,
install the transaxle case over the clutch housing as shown.
e. Through the bore plug mounting hole, with the snap ring
stretched, lift up the mainshaft assembly from the control
assembly mounting hole.
f. Securely install the snap ring onto the mainshaft rear bearing as
shown.
g. Tighten the “A” bolts (gold) and new “B” bolts (black) to specifi-
cation.
CAUTION:
Always replace the “B” bolts as they are self-sealing bolts.
h. Apply gear oil to the O-ring and install it to the control assembly. Then install control assembly to transaxle
case. Tighten bolts to the specified torque. Refer to MT-87, "
SHIFT CONTROL COMPONENTS" .
CAUTION:
Do not reuse the O-ring.
i. Install a new shift check and a new stopper bolt.
CAUTION:
Shift check and stopper bolt are not reusable.
SCIA0892E
SCIA0893E
“A” Bolt : 52.0 N-m (5.3 kg-m, 38 ft-lb)
“B” Bolt : 65.0 N-m (6.6 kg-m, 48 ft-lb)
SCIA1064E