Owner's manual

2. Secure the child restraint anchor attach-

ments to the LATCH lower anchors.

3. The back of the child restraint should be

secured against the vehicle seatback.

If the seating position does not have an adjust-

able head restraint and it is interfering with the

proper child restraint fit, try another seating posi-

tion or a different child restraint.

4. For child restraints that are equipped with

webbing mounted attachments, remove any

additional slack from the anchor attach-

ments. Press downward and rearward firmly

in the center of the child restraint with your

knee to compress the vehicle seat cushion

and seatback while tightening the webbing

of the anchor attachments.

5. If the child restraint is equipped with a top

tether strap, route the top tether strap and

secure the tether strap to the tether anchor

point. See “Top tether strap child restraint”in

this section.

6. Before placing the child in the child restraint,

hold the child restraint near the LATCH at-

tachment and use force to push the child

restraint from side to side, and tug it forward

to make sure that it is securely held in place.

It should not move more than 1 in (25 mm). If

it does move more than 1 in (25 mm), pull

again on the anchor attachments to further

tighten the child restraint. If you are unable to

properly secure the restraint, move the re-

straint to another seating position and try

again, or try a different child restraint. Not all

child restraints fit in all types of vehicles.

Front facing web-mounted – step 2

LRS0663

Front facing rigid-mounted – step 2

LRS0664

Front facing – step 4

LRS0671

1-22 Safety—Seats, seat belts and supplemental restraint system

Z REVIEW COPY—

2007 Altima (alt)

Owners Manual—USA_English (nna)

10/26/06—debbie