Owner's Manual User guide

and you change the priority level of Phone C to
Level 1, then:
Priority Level 1 = Phone C
Priority Level 2 = Phone B
Priority Level 3 = Phone A
“Delete phone”
䊊
E
Use the Delete Phone command to delete a
specific phone or all phones from the Bluetooth姞
Hands-Free Phone System.
The system announces the names of the phones
already paired with the system and their priority
level. The system then gives you the option to
deleteaspecificphone,allphonesor listen to the
list again.
Onceyouchoosetodeleteaphoneorallphones,
the system asks you to confirm this action.
NOTE:
When you delete a phone, the associated
phone book for that phone will also be
deleted.
“Select ringtone”
䊊
F
Use the Select Ringtone command to select the
toneheardin the vehicle whenan incomingcall is
received.
The system announces the name of the active
phone and asks you to choose from the following
commands:
●
“Ringtone”—Thesystemplaysaringtoneand
asks if youwould liketo selectthat tone. If you
say “No”, the system plays the next ringtone
available and continues to cycle through the
ringtones until you select one or quit.
● “Silent” — The system asks you to confirm
your wish to disable the ringtone.
“Bluetooth off”
䊊
G
Use the Bluetooth Off command to turn off the
Bluetooth姞 Hands-Free Phone System.
When the Bluetooth姞 Hands-Free Phone Sys-
tem is off, you will not be able to make or receive
callsusing NISSANVoiceRecognition. Also,you
will not have access to the Phone Book.
You can still use the Memo Pad and access
Setup.
SPEAKER ADAPTATION (SA) MODE
Speaker Adaptation allows up to two out-of-
dialect users to train the system to improve rec-
ognition accuracy. By repeating a number of
commands,the userscancreateavoicemodelof
their own voice that is stored in the system. The
system is capable of storing a different speaker
adaptation model for memory A and memory B.
If memory A is available, the system will use
memory A to store the model. If memory A is in
use and memory B is available, the system will
use memory B to store the model. If both of the
memory locations are in use, the system will ask
the user to select which memory location should
be overwritten.
Training procedure
The procedure for training a voice is as follows.
1. Position the vehicle in a reasonably quiet
outdoor location.
2. Sit in the driver’s seat with the engine run-
ning,theparking brake on,and thetransmis-
sion in P (Park) (AT and CVT models) or N
(Neutral) (MT models).
3. Press and hold the
button for more
than 5 seconds.
4. The system announces: “Press the
PHONE/SEND (
) button for the
hands-free phone system to enter the
speaker adaptation mode or press the
PHONE/END (
) buttonto select a dif-
ferent language.”
5. Press the
button.
For information on selecting a different lan-
guage, see “Choosing a language”earlier in
this section.
Heater, air conditioner, audio and phone systems 4-41
墌 REVIEW COPY— 2009 Versa (vrs)
Owners Manual—USA_English (nna)
09/10/08—debbie
墍