Owner's Manual Instruction Manual

Shoulder belt height adjustment (front

and 2nd row outboard seats)

The shoulder belt anchor height should be ad-

justed to the position best for you. (See “Precau-

tions on seat belt usage” earlier in this section.)

To adjust, pull out

䊊

the adjustment button and

move the shoulder belt anchor

䊊

to the desired

position so the belt passes over the center of the

shoulder. The belt should be away from your face

and neck, but not falling off your shoulder. Re-

lease the adjustment button to lock the shoulder

belt anchor into position.

WARNING

● After adjustment, release the adjust-

ment button and try to move the shoul-

der belt anchor up and down to make

sure it is securely fixed in position.

● The shoulder belt anchor height should

be adjusted to the position best for you.

Failure to do so may reduce the effec-

tiveness of the entire restraint system

and increase the chance or severity of

injury in an accident.

Seat belt hook

When the seat belt is not in use and when folding

down the rear seats, hook the rear seat belts on

the seat belt hooks.

SEAT BELT EXTENDERS

If, because of body size or driving position, it is

not possible to properly fit the lap/shoulder belt

and fasten it, an extender that is compatible with

the installed seat belts is available that can be

purchased. The extender adds approximately 8 in

(200 mm) of length and may be used for either

the driver or front passenger seating position.

See a NISSAN dealer for assistance with pur-

chasing an extender if an extender is required.

Front and 2nd row outboard seats

LRS0242

LRS0515

Safety—Seats, seat belts and supplemental restraint system 1-25