Owner's Manual Owner manual

Black plate (222,1)
[ Edit: 2012/ 5/ 18 Model: S35-D ]
4-74 Center display, heater, air conditioner, audio, phone and voice recognition systems
GETTING STARTED
S35-D-110201-363B37 16-4171-4E1D-92BB-B6C8C2F728AD
The following procedures will help you get
started using the Bluetooth
®
Hands-Free Phone
System with NISSAN Voice Recognition. For
additional command options, refer to “List of
voice commands” later in this section.
Choosing a language
S35-D-110201-9ED1490B-F9A5-48AB-ADF8-DA6C6BE9BBA1
You can interact with the Bluetooth
®
Hands-
Free Phone System using English, Spanish or
French.
To change the language, perform the following.
1. Push and hold the
button for more than
5 seconds.
2. The system announces: “Push the PHONE
SEND (
) button for the hands-free
phone system to enter the speaker adapta-
tion mode or push the PHONE END (
)
button to select a different language.”
3. Push the
button.
For information on speaker adaptation, see
“Speaker Adaptation (SA) mode” later in this
section.
4. The system announces the current language
and gives you the option to change the
language to Spanish (in Spanish) or French
(in French). Use the following chart to select
the language.
NOTE:
You must push the
button or the
button within 5 seconds to change
the language.
Current lan-
guage
Push
(TALK/
PHONE SEND)
to select
Push
(MODE/
PHONE END)
to select
English Spanish French
Spanish English French
French English
Spanish
5. If you decide not to change the language, do
not push either button. After 5 seconds, the
VR session will end, and the language will
not be changed.
Connecting procedure
S35-D-110201-70B0342B-394D-4E2C-ACD1-017AECE46CD1
NOTE:
The connecting procedure must be per-
formed when the vehicle is stationary. If
the vehicle starts moving during the pro-
cedure, the procedure will be cancelled.
NOS2623
1. Push the button on the steering wheel.
The system announces the available com-
mands.
2. Say: “Connect Phone”
*
A
. The system
acknowledges the command and an-
nounces the next set of available commands.
3. Say: “Add phone”
*
B
. The system acknowl-
edges the command and asks you to initiate
pairing from the phone handset
*
C
.
The connecting procedure of the cellular
phone varies according to each cellular
phone. See the cellular phone Owner’s
Manual for details. You can also visit www.
nissanusa.com/bluetooth for instructions on
connecting NISSAN recommended cellular
phones.
When prompted for a Passkey code, enter
“1234” from the handset. The Passkey code
“1234” has been assigned by NISSAN and
cannot be changed.
4. The system asks you to say a name for the
phone
*
D
.
If the name is too long or too short, the
system tells you, then prompts you for a
name again.
Also, if more than one phone is connected
and the name sounds too much like a name
already used, the system tells you, then