Quick start Guide

15
Nomenclature
How to pair with Commander Air 1Mode and function
1 Fill-in reflector
2 Flash head
3 Light diffusing panel
4 Video light
5 Remote/ Slave sensor
6 AF-assist light
7 Battery pack adapter
8 Mounting foot and Hotshoe contacts
Accessories:
9 Color monitor
10 Pilot button (Test flash button)
11 Mode dial
12 Control wheel and button
13 Power button
14 Unlock button
15 Battery compartment door
NP477.8.16.04
Pouch
Flash stand
Soft box
TTL Program
Mode
Manual zoom
Manual Setting
Mode
Full Automatic
Mode
Lock
Pilot Button
Slave Film
Mute
Video light
High-speed
synchronization
Wireless Channel
Slave Digital
Wireless
Quick Manual
NAS mode
A: Group A B: Group B C: Group C
Optical mode
Sony:
A: RMT TTL B: RMT2 TTL C: RMT M
Canon, Nikon & Four Third:
A: Group A B: Group B C: Group C
Power
Press once to turn on or off.
Built in video light with 9 steps of
output level adjustment.
Before the pairing begins,
make sure your i60A and
Air 1 are turned off.
Flash light is fully controlled by the camera
for the most proper exposure.
Flash light is automatically controlled
by the camera but the flash exposure value
can be compensated.
Selecting the desired manual power
on the flash unit.
Hold the button for 1 second to activate or
deactivate High speed synchronization.
Hold the button for 1 second to activate or
deactivate the Mute function.
Hold the button for 1 second to change
wireless channel during wireless mode.
Hold the button for 1 second to change
zoom head position.
Hold the button for 1 second to lock or
unlock all the buttons on the right side dial.
Press once to test-flash
Green: flash ready Red: flash recharging
Yellow: Nissin Air System Pairing mode
Wireless TTL
Slave Mode
1
Hold the Power button and
Lock button on your i60A
until you hear the beeping sound.
2
HOLD 3 Sec.OFF
Hold the S button and
Power button on your Air 1
until the Pilot light is flashing.
3
After the pairing is done,
the i60A and Air 1 will
stop beeping and flashing.
4
DONE!
unlock
Mode
A
B
C
Z
S
HOLD 3 Sec.
Optical mode will activate automatically
when no NAS signal, or 6 seconds after
disconnected from other NAS device.
(Optical mode not available for Fujifilm system)
Contents are subject to change without further notice.
Scan the code or
go to the “Nissin Digital Global”youtube channel
to watch the pairing guide.
Compatible with
Nissin Air System