Quick Manual

Mounting MF18 on the Camera
Lock ring
Lock pinHotshoe contacts
Hotshoe contacts
LED lamp
Flash tube
USB port
X-terminal
Power Pack socket
Mounting tabs
Expension button
Release button
Display screen
Set button
Pilot button
Select button
On/Off switch (Lock button)
1. Turn off the power switch of both MF18 and the camera.
2. Loosen the lock ring of MF18 so the hotshoe mounts easily.
3. Slide the mounting foot of MF18 into the hotshoe of the camera from the back.
4.Turn the lock ring to opposite direction and tighten it.
5. Screw the adapter ring that is the same size as the lens onto the front thread
of the lens.
6. Attach the flash head to the adapter. Press the release buttons on both sides
of the flash head to insert the four mounting tabs on the inside of the flash
head correctly into the groove on the adapter ring.
7. After the flash head is attached, pull it lightly to make sure the tabs are
inserted into the groove correctly.
External service box
MF1111 REV. 1.1
Main Menu and Setting
A
B
Adapter Rings x 6 (Included)
*49 / 55 / 82 mm (optional for purchase)
Extra battery magazine
(optional for purchase)
52 / 58 / 62 / 67 / 72 / 77 mm
EV
A:B
1:2.8
Fine Macro
Side A
Side B
/512
1
-1/6EV
/512
1
-1/6EV
Side A
Side B
1/4
-1/3EV
Manual
1/4
-1/3EV
Setting
Expansion of the Flash Head
Press the expansion buttons on the sides of flash head.
The flash head is expanded. It is possible to expand one side if necessary.
1.
2.
After the flash head is attached, it is suggested to expanse the flash ring
when there has dark corners appear in the film (It is also depending on the
angle of view).
Remark: This Macro flash is preferable to apply on macro lens. For zoom lens, please adjust the
suitable position to prevent the dark corners.
To close the expansion, push it lightly back to the original position.
3.
Press the on/off switch. Main screen appears.
The pilot lamp blinks red showing the unit is charging.
In a few seconds, the pilot lamp turns green.
The display screen automatically turns off in about 30 seconds after the
setting job is terminated.
For a test-flash, press the pilot lamp.
To turn off the flash unit manually, press the on/off switch and hold it for 2
seconds.
Loosen the lock ring and slide the mounting foot of MF18 off the hotshoe of
the camera. Make sure to turn the lock ring all the way to completely clear
the lock pin off the hooking slot on the hotshoe. Press the release button on
the flash head and remove. Screw the adapter ring off the front thread of the
lens.
Turn on the flash unit
Removing MF18 from the Camera
1.
2.
Auto mode TTL mode Master mode
Fine Macro mode Manual mode Setting mode
Master
Channel
/
- EV
+
---
Setting
Shutter
Canon versionNikon version