User Manual- Air 10s

Wireless Flash Shooting

NAS

Step 2: Pairing on Nissin Air 10s commander

1. Start the Pairing mode of all slave units and the "beep" sound are constantly heard.

2. Turn off Nissin Air 10s then hold the Panel Lock key and

the power “On/Off” button for 3 seconds at the same time.

The Pilot LED will blink about ten seconds (the display will not light up while pairing).

When Nissin Air 10s Pairing mode has stopped, slave units around the commander

will also complete the pairing process one by one, and stop the "beep" sound.

3. To check the pairing between Nissin Air 10s and slave units,

press the “Pilot LED” button on Nissin Air 10s for test and let NAS flash and

the flash on NAS receiver emit a weak output test flash.

CAUTIONS

If strobes still have "beep" sound constantly after finishing the pairing process, this

means the pairing process is not complete. Please move your Air 10s towards the

Beeping strobes, then turn off the Air 10s and re-do the pairing process by holding

Panel Lock key and the “On/Off” button again for 3 seconds.

(*) Nissin Di700A, i60A ash and Nissin Air R receiver do not support the Channel 1 in Nissin Air 10s.

Please use Channel 2 to 8 to pair with those 3 NAS slave unit models.

The default channel setting is no. 2.

If you want to change this setting then press the channel button for 2 second.

Press channel button 2 second to exit setting.

i60A / Di700A / Air R

MG10 Ch.2 - 8

Ch.1 - 8

Ch.2 - 8

Air1 Air 10s