User Manual- Air 10s

Inserting batteries
1. Open the battery compartment door and
insert 2 x size AAA batteries as shown
in the picture.
2. Make sure the + and - battery contacts are
correctly inserted in the battery compartment.
3. Close the battery compartment door and
slide it back in place.
CAUTIONS
It is recommended to use 2 batteries of the same brand and type, and replace them
all at the same time.
Wrong insertion of each battery would not make electric contact.
Before starting wireless flash shooting.
5
2
1
1
2
(*) Air 10s has an energy saving power off function
To save battery energy, the screen of Air 10s display dims in about 30 seconds and
turns off in about 2 minutes automatically after the setting job is terminated. While Air
10s is in the stand-by mode, a blinking signal will be shown on the Pilot Button. To
turn on Air 10s again, press any button on the Commander. In case of not in use for
over 60 minutes, Air 10s will be turned off completely. To turn on Air 10s again, press
Power button on the Commander.