Full Product Manual

Do not allow children to install or operate the light.

Do not install the light in poor weather conditions, especially when lightning is present.

Ensure the area where the light is being attached is free from wires, plumbing or other

obstructions.

If using a ladder, ensure the footing is secure before climbing and obtain assistance when

needed.

Wear protective equipment such as safety glasses, dust masks and gloves when installing

the light.

Ensure the area where the light is being installed is structurally sound and will support the light.

Do not hang anything from the light.

Clear any snow or other objects from resting on top of the light.

Motion-Activated Solar Powered LED Spotlight

with Light Sensor

Model: NLS650M

IMPORTANT: Keep this manual for future reference.

IMPORTANT SAFETY INSTRUCTIONS

READ AND FOLLOW ALL INSTRUCTIONS

Installation

IMPORTANT: Ensure that the location of where the

light will be installed allows for adequate sunlight

throughout the day to charge the battery sufficiently. Be

mindful of overhangs or shaded areas.

1. Unfold the light and remove any packaging.

2. Remove the mounting plate from the solar panel by

pulling down on the plate and up on the light/panel.

3. Place the plate in the desired area, ensure the plate

is level and mark the hole locations.

4. Predrill the marked holes with an appropriate sized

drill bit (mounting surface will determine the drill bit

required).

NOTE: The surface on which the light is being mounted

will determine the type of installation required. Masonry

surfaces such as brick or concrete will require the use of

a masonry bit and plastic anchors/screws. Installation

into a wooden surface or some engineered surfaces may

only require the use of the provided screws. Longer

screws may be required depending on the installation.

PAGE 1
® Motion-Activated Solar Powered LED Spotlight with Light Sensor Model: NLS650M IMPORTANT: Keep this manual for future reference. IMPORTANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS ! Do not allow children to install or operate the light. ! Do not install the light in poor weather conditions, especially when lightning is present. ! Ensure the area where the light is being attached is free from wires, plumbing or other obstructions.
PAGE 2
5. Once the holes are predrilled, realign the mounting plate and secure with screws. Operating the Light 1. Slide the switch of the light to the ON position. The light will flash indicating it is on. 2. Allow the light to charge during the day. 3. After dark, walk past the light to have it illuminate. 4. Finalize the position of the lamps if necessary. 5. The light will turn off after 30 seconds of not detecting movement. 6. Slide the light/solar panel over the mounting plate t o secure in place. 6.