User's Manual

- 32 -
Normal / Latent
／ Intelli / LFD
- LFD level menu will be supported only when you use LFD firmware.
The default value is LFD
 Sensor Timeout (1 ~ 30 seconds)
Set the timeout of fingerprint input. The LED blinks and the
terminal waits for fingerprint input during the specified seconds.
After that time, the LED will be turned off. The default is 『5 』. Use
the number keys to enter the value and press the Enter key.
Ｓｅｎｓｏｒ Ｔｉｍｅｏｕｔ
（１ － ３０）: ５
 Auto-On Check
This feature can increase security but it may slow down
authentication time. So if high level of security is required,
you can use this feature. But you'd better not use this
feature in an environment where convenience and
quickness are more important (i.e. when used fo
r
attendance management).