User's Manual

- 64 -
⑦ Input RF card.
If you chose to use RF card when you setup the system, use the
RF card to register the user. Place the RF card near the
fingerprint input sensor. If you did not choose the RF option
when you setup the terminal environment, press the Enter key to
go to the next step.
Ｃｏｎｔａｃｔ ＲＦ Ｃａｒｄ
Ｏｎ Ｓｅｎｓｏｒ
If the RF input is successful, a success message will appear. If it
fails, a failure message will appear and you will return to the
initial registration screen.
 Modify User
Use this feature to change the information on a registered user.
You can change fingerprint, password, group ID, RF card,
authentication mode and user type. If you select『Ｍｏｄｉｆｙ
Ｕｓｅｒ』, the following screen will appear so that you can enter
the user ID whose information you want to modify.
Ｉｎｐｕｔ ＩＤ
１２３４
Enter the ID and press the Enter key, and you'll see the following
items in the displayed screen. Move to the submenu you want to