User's Guide

eNBioAccess-T9 user guide 53
NITGEN Co,. Ltd / #1208 ,641-4, Munjeong-dong, Songpa-gu, Seoul, Korea (138-050)
Tel: [phone], Fax: [phone], E-Mail: [e-mail]
▶ Tamper Alarm
If this is checked ( ), warning sound will be made when the terminal is disassembled.
To apply the setting value, press [OK] button, or press [BACK] button to cancel and to
move to the upper menu.
3.7.4. Lock setting
Select [Terminal]  [Lock] in the main menu to display the screen below.
▶ Default setting: same with the setting in the left
screen
▶ Lock 1 option
- Not use: when it is not used
- Strike/Auto/successful authentication notice: warning lamp to indicate Strike type,
auto door or authentication success/failure is connected to Lock1
- Motor lock 1: when a motor lock is connected
▶ Lock 2 option
- Not use: when it is not used
- Authentication failure notice: warning lamp to indicate authentication failure is
connected to Lock2
- Motor lock 2: when a motor lock is connected
▶ Lock 1 Duration (ms)
This is to designate time to give signal when Lock 1 is set to „Strike/Auto/successful
authentication notice‟. Since it is set to ms unit, set it to 3000 to designate it to 3
seconds. Strike type means time until the door is closed again when the door is open
after authentication.
▶ Lock 2 Duration (ms)
This is to designate time to give signal when Lock 2 is set to „authentication failure
notice‟. Since it is set to ms unit, set it to 3000 to designate it to 3 seconds.