Instruction Manual

Nitrous Express Accumulator
PN: SPEED00010
The NX Accumulator is simply a high pressure fuel reservoir
to assist your EFI fuel pump when the engagement of the
nitrous system causes a momentary drop in fuel pressure.
The accumulator is supplied with everything you will need
for a professional installation, see Figure 1
Figure 2
Figure 3
Figure 4
Begin the installation by installing the barbed hose  ttings
in their proper locations. Use the supplied thread sealing
compound.
With the  ttings installed as shown in Figure 2 proceed with
installing the high pressure Aeroquip blue hose on the inlet
side of the Accumulator. The D-6 180 degree Aeroquip  tting
is installed on the opposite blue hose end. These are high
pressure push-on design  ttings and requires no clamps.
(see  gures 3 & 4) The low pressure black hose requires
no clamps, this is simply a drain in case of accumulator
leakage.
Figure 5
After assembly of the accumulator unit is complete, remove
the  tting at the back of the NXL fuel rail, see Figure 5. Either
rail may be used but the passenger side is recommended
for accumulator mounting convenience. Install the Aeroquip
D-6 rail  tting with the o-ring facing the NXL rail. No thread
sealer is required on this  tting. Figure 6.
Figure 1