Owner manual

MOUNTING THE NITROUS PLATE:

Before any modifications are made under the hood, we suggest that you make a diagram of all hoses

wiring and linkages.

1. Pre-assemble the nitrous plate before you begin. Select the horsepower setting that you want to start

with, insert the proper nitrous jet in the fitting marked “N2O” (CAUTION: You must always use a

back-up wrench when tightening the nitrous or fuel fittings, failure to do so will void the system

warranty!!!!!) Connect the blue stainless feed line to the plate fitting. The nitrous fitting can be

identified by the “N2O” marked on the plate. Repeat this procedure for the red fuel line (the fuel fitting

will be marked “FUEL”). NOTE: Always check each jet for obstructions before installing.

2. Remove the throttle body.

3. Using the supplied O-ring, re-install the throttle body in front of the nitrous plate and torque to factory

specs using the provided hardware.

4. Install plate as shown below in ILLUSTRATION C

ILLUSTRATION C