1. Overview The Maximizer 4 progressive nitrous controller operates one or two separate stages of nitrous based on either time, RPM, MPH, throttle percentage or boost pressure. Whether your engine is naturally aspirated or forced induction, gasoline or diesel, the Maximizer 4 is the first choice. The Maximizer 4 has multiple progression options to cover a variety of racing types. These progression options are described below: Time based progression.
2. MAX-4 hardware installation The MAX-4 is designed to be installed almost anywhere on the vehicle. Select a location that is away from heat sources that can damage the wires. Mounting in a dry location is also recommended so that the USB connections to not corrode. The MAX-4 controls the nitrous and fuel solenoids by varying the pulse width to the ground wires of the solenoids.
Single or Dual Stage wiring WITHOUT AFR CORRECTION:
Single Stage Wiring WITH Wide-Band o2 AFR Correction: 3. PC Software Installation DO NOT connect the controller to your PC until you have installed the software. If you have the autorun feature enabled on your cd rom drive, wait for the navigation screen and follow the instructions to install the software. If the application does not auto-start, go to the cd rom directory and run “setup.exe” 3.
3.2 Tuning Configuration The Tuning/Configuration selection allows you to set the input configurations as well as enable the stage selections. Note, when using stage 1 and /or stage 2, the wiring is different than if you are using the AFR Correction Closed Loop selection. Under the Tuning / Configuration menu, you may enable Stage 1, Stage 2 or AFR Correction Closed Loop. 3.
RPM Cutoff allows you to set the upper RPM threshold above which the nitrous will be turned off. If you remove the check mark the nitrous will not turn off at the cutoff. RPM Trigger allows you to set the minimum RPM required before the Nitrous can be triggered. 3.5 Ramp Set-up The software allows you to drag and drop any dot on the ramp between 0-100%. The controller will extrapolate between the dots thus creating a nitrous curve instead of the traditional ramp.
parts thereof, at the election of the Warrantor, without charge to the consumer for such repair or replacement. This Limited Warranty shall not apply to labor charges, freight, material or other incidental expenses in connection with removal and/or replacement of such defective product on the consumer’s vehicle. This Limited Warranty shall extend for a period of ninety (90) days, commencing from the date of the original purchase by the Consumer.
