Medicine Cabinet homeland com/ GORY THE MODEL NUMBER FOR YOU RECORDS HERE # 48"W x 36"H READ THE INSTRUCTIONS CAREFULLY, familiarize yourself with all the parts as shown in the exploded view. The exploded view will also provide a helpful reference when relating fo the location of the various parts and how they are mounted.
PARTS LIST.
Determining Measurement and Direction: Model No.| Height Width Depth | Tolerance 4836 3s” 47 1/2" 4" +1/8" 1" clearances Fig 2 Fig 1 9 If needed ,please turn over the upside to downside ,you may get the opposite hand installations .
Recessed or semi-recessed 1. Pull off the side kits from the cabinet as figure shown. Top View Top View Semi-recessed 2. Make sure hinges are on correct side of opening for left hand or right hand operation. Place cabinet box into rough opening. On fully recessed applications, make sure cabinet flange covers rough opening evenly all around {Fig 3). On semi-recess applications, mirror edges should meet wall surface. {Fig 4). Shim as needed. Fig 3 Fig 4 3.
How to Surface Mount Cabinet If installing in combination with a middle mirror/shelf kit, please see “Center Mirror/Shelf Kit Installation” Directions that came with your canter mirror prior fo preforming the steps below 1. Establish precise height and draw a level horizontal line (Fig 6). IMPORTANT: Detect medicine cabinet at precise height. Make sure there is at least 1" of clearance above any obstructions. 2.
4. Insert surface mount z-clips@ as shown (Fig 8 & 10). Lad Lad Fig 10 Fig 5. Place cabinet into wall bracket (Fig 11). Mark hole locations of z-clips (Fig 12). When determining location, it is recommended that at least ona z-clip be located at a stud | Detach cabinet and drill 8mm hole if needed for anchor, and place in anchor in hole. 8 .Remount cabinet and connect with screws (Fig 13).
Door Installation 1 Remove protective packaging from door be careful not to bump edges of mirror. Line hinges up against hinge mounting plates. Snap into position ] (Fig 14). ) Mounting Plate Snap into position Button Pull to release Fig 14 2 .Door should “snap” locked when about 1" from being fully closed. Door should be placed even in relation to cabinet.
Limit Clips Limit Clips are provided should you need to reduce the opening swing of the cabinet door from 170 degrees to 130 degrees {see lop view) This will eliminate the possibility of the door hitting a wall sconce or other decorative items. Additional item Installation 1 .Insert clear shelf clip) into appropriate hole location using 2 clips per shelf (Fig 16). Fig 18 3 Fill remaining holes with hole plugs(3) (Fig 18). Fill the rest of shelf clip holes with decorative covers {3 (Fig 18).
Install cover plate COVER PLATE (2 pes) Pasting Nameplate 1.