Datasheet

H
Series JS01 & JS03
Ultra-Miniature Slide & Piano DIP
www.nkk.com
H18
Indicators
AccessoriesSupplement
Tactiles
KeylocksRotaries
Pushbuttons
Illuminated PB
Slides
Programmable
Rockers
Touch Tilt
Toggles
Electrical Capacity (Resistive Load)
Switching Rating: 25mA @ 24V DC
Nonswitching Rating: 0.1A @ 50V DC
Other Ratings
Contact Resistance: 50 milliohms maximum
Insulation Resistance: 100 megohms minimum @ 500V DC
Dielectric Strength: 500V AC minimum for 1 minute minimum
Mechanical Life: 2,000 operations minimum
Electrical Life: 2,000 operations minimum
Total Travel: For slide actuator: .031” (0.8mm); for piano actuator: .114” (2.9mm)
Materials & Finishes
JS01 Slide DIP JS03 Piano DIP
Actuator: Glass fiber reinforced polyamide Glass fiber reinforced PBT
Cover: Glass fiber reinforced polyamide (UL94V-0) Glass fiber reinforced PBT (UL94V-0)
Base: Glass fiber reinforced polyamide (UL94V-0) Glass fiber reinforced PBT (UL94V-0)
Contacts: Beryllium copper with gold plating Phosphor bronze with gold plating
Terminals: Brass with gold plating Phosphor bronze with gold plating
Environmental Data
Operating Temp Range: –25°C through +70°C (–13°F through +158°F)
Humidity: 90 ~ 95% humidity for 96 hours @ 40°C (104°F)
Vibration: 10 ~ 55Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range & returning
in 1 minute; 3 right angled directions for 2 hours
Shock: 50G (490m/s
2
) acceleration (tested in 6 right angled directions, with 5 shocks in each direction)
PCB Processing
Soldering: Wave Soldering Recommended. See Profile A in Supplement section.
Manual Soldering: See Profile A in Supplement section.
Note: Switches are packaged in OFF position and should be soldered in OFF position.
Cleaning: These devices are not process sealed. Hand clean locally using alcohol based solution.
Standards & Certifications
Flammability Standards: UL 94V-0 rated cover & base
The JS series devices have not been tested for UL recognition and CSA certification.
These switches are designed for use in a low-voltage, low-current circuit.
When used as intended in a low-voltage, low-current circuit, the results do not produce
hazardous energy.
General Specifications

Summary of content (5 pages)