Owner manual

NM Engineering ∞ 3300 Corte Malpaso, Camarillo, CA 93012 ∞ 805.388.7171 ∞ 805.388.0030 FAX
[e-mail] ∞ www.nm-eng.com
PARTS INCLUDED: TOOLS REQUIRED:
[1] Titanium Heat Shield [3] M5x8mm SS Button Head Bolt [1] 10MM Wrench [1] 13MM Wrench
[2] Stainless Steel Hex Stand-Offs [3] M5 SS Serrated Washer [1] 3mm Hex Key Wrench [1] 13MM Socket
[1] Stainless Steel Support Bracket [2] M6 SS Washer [3] M5 Lock Washer [1] Torque Wrench
1. Using a 10mm wrench, remove turbo housing bolt.
2. Mount supplied SS Support Bracket to turbo housing using
original bolt.
3. Torque bolt to 20Nm (15ft-lbs.). Top surface should be
horizontal. Correct as necessary.
4. Install Hex Stand-offs with 6MM SS washers (washers not
shown) into threaded ears on cylinder head.
5. Tighten using a 13mm wrench. NOTE: Torque to 10 ft-lbs.
6. Mount NM Titanium Heat Shield using M5x8mm SS button
head bolts and M5 SS serrated washers supplied, and then
tighten with 3mm hex key wrench. Installation is complete.
©2011 NM Engineering, a division of Automotive Performance Systems, Inc.
All rights reserved. Reproduction in whole or in part is prohibited.
DOC. NM.688857 Rev. 07.07.11
TITANIUM HEAT SHIELD – NM.688857
[R55] MINI Cooper S Clubman 2011
[R56] MINI Cooper S Hardtop 2011
[R57] MINI Cooper S Convertible 2011
[R60] MINI COUNTRYMAN 2011